Renault Clio III 2.0 Renaultsport 200/Gordini 200
Engine code: F4R 832 (B/C/K/S85) (05-15)
147 kW (200hp) 7100 rpm, R-Cat (2009-2013)
| Cylinder head | Renew bolts: Yes 1. 30 Nm 2. 30 Nm 3. 180°±25°  |
| Oil pump to cylinder block | 24 Nm |
| Sump bolts | Tighten bolts in the following stages: 8, 15, 4, 19, 12, 11 = 15 Nm 10, 13, 9, 14 = 18 Nm 8, 15 = 18 Nm 7, 16, 6, 17, 5, 18, 3, 20, 2, 21, 1, 22 = 18 Nm Sump bolts to gearbox = 44 Nm Engine tie-bar bracket to sump = 62 Nm  |
| Sump drain bolt | 20 Nm |
| Flywheel/driveplate | 30 Nm+60°±10°/- |
| Clutch pressure plate | 20 Nm |
| Crankshaft pulley/damper centre bolt | 40 Nm+110°±10° |
| Camshaft sprocket/gear | Use new nuts/bolts. Tighten in the following stages: VVT sprocket: 1. 30 Nm 2. 90 Nm VVT centre plug = 15 Nm Exhaust camshaft sprocket: 1. 30 Nm 2. 86°±6° |
| Camshaft carrier/cap/rocker cover | Apply sealant to mating surface of camshaft carrier using a stipple roller. Remove excess sealant from the camshaft carrier bearing channels. Excess sealant can cause engine damage. Tighten bolts in the following stages: Bolts 22, 23, 20, 13 = 8 Nm Bolts 1-12, 14-19, 21 and 24 = 12 Nm Slacken off bolts 22, 23, 20 and 13, then retighten to 12 Nm.  |
| Inlet manifold to cylinder head | 15 Nm |
| Exhaust manifold to cylinder head | 30 Nm |
| Water pump | 17 Nm |
| Spark plugs | 28 Nm |
| Fuel rail | 10 Nm |
| Crankshaft position (CKP) sensor/engine speed (RPM) sensor | 10 Nm |
| Engine coolant temperature (ECT) sensor | 33 Nm |
| Lambda sensor (Oxygen) | 44 Nm |
| Engine oil pressure switch | 30 Nm |
| Front hub | 280 Nm Use new nut. Before refitting driveshaft ensure splines and threads have been degreased. Apply locking fluid to nut and splines. |
| Rear hub | 175 Nm Use new nuts. |
| Steering wheel | 44 Nm Use new nuts. |
| Steering rack/box mounting | 110 Nm Use new nuts/bolts. |
| Steering track rod end | 37 Nm Use new nuts. |
| Brake disc to hub | Front: 21 Nm Use new nuts/bolts. |
| Brake caliper/carrier to hub | Front: 160 Nm |
| Brake caliper to carrier | Rear: 32 Nm Use new nuts/bolts. |
| Brake caliper/carrier to hub | Rear: 105 Nm |
| Road wheels | 140 Nm Lightly coat mating surfaces between wheel centre hole and hub (use copper anti-seize grease). |